It is interesting and helpful to know that the behavior is different (and better) when using Hyperterm or Teraterm. Timeouts: Idle EXEC Idle Session Modem Answer Session DispatchĭNS resolution in show commands is enabled
Special Chars: Escape Hold Stop Start Disconnect Activation
Status: PSI Enabled, Ready, Active, No Exit Banner, Ctrl-c Enabled Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int So to me this looks like the program is the cause, not the switch.Nevertheless here is the line setting: Only when I use Procomm (which a I said I prefer) it is not. When I use Hyperterminal or Teraterm the feedback is given page-by-page. I was also wondering if it is the line setting in the switch or the program I use to connect (Procomm) which causes this.īefore I post the configuration of line settings, this might be a clue to what is the cause:
0 kommentar(er)
